A simple top and bottom case for an ESP32 development board sitting on a GPIO breakout or expansion board. The pins and ports stay open, and the two halves click together.
Print it
- Top and bottom: about 1 h 12 min, 27 g of filament (PLA)
- Filament: PLA or PETG, one color, no AMS (Automatic Material System)
- Board: an ESP32 dev board on a GPIO breakout or expansion board
- Parts: the full parts list, with where to buy each part, is on the MakerWorld page
Times and weights are from the PLA print profile on MakerWorld (November 2026).
Build it
- Print the top and the bottom.
- Set the expansion board into the bottom.
- Click on the top.
Get the ESP32 Dev Board Case on MakerWorld
Sell printed ESP32 dev board cases
Small project cases are handy add-ons if you sell boards or kits to makers. The ESP32 Dev Board Case is one of our Exclusive models, so our Commercial License covers it: Local ($5 a month) for markets, craft fairs and school fairs, or Online ($15 a month) for Etsy and other online shops.
Questions
Which board does it fit?
An ESP32 development board on a GPIO breakout or expansion board. The exact board is linked on the MakerWorld page.
Do I need an AMS?
No. It prints in one color with no AMS (Automatic Material System).
Can I sell printed ESP32 dev board cases?
Yes, with our Commercial License: Local ($5 a month) for markets, craft fairs and school fairs, or Online ($15 a month) for Etsy and other online shops. The free download is for personal use.
More Electronics
ESP32 Stream Cheap Deck · ESP32 Supermini Case · ESP32 Supermini Breakout Case