A small snap-fit case for the ESP32 Supermini C3 or S3 board. Print it, click in the board and click on the lid. Four versions come on the plates, with or without button holes and with slots or solid, and you can mix and match the parts.
Print it
- Four versions on a plate: about 1 h 31 min, 15 g of filament (PLA, C3)
- Boards: ESP32 Supermini C3 or S3, each with its own print profile
- Filament: PLA or PETG, one color, no AMS (Automatic Material System)
- No screws: the board clicks in and the lid clicks on
- Parts: the full parts list, with where to buy each part, is on the MakerWorld page
Times and weights are from the PLA print profile on MakerWorld (November 2026). It has been downloaded more than 1,000 times.
Build it
- Print the plate for your board, C3 or S3.
- Click the board into the case.
- Click on the lid.
Get the ESP32 Supermini Case on MakerWorld
Sell printed ESP32 Supermini cases
Small project cases are handy add-ons if you sell boards or kits to makers. The ESP32 Supermini Case is one of our Exclusive models, so our Commercial License covers it: Local ($5 a month) for markets, craft fairs and school fairs, or Online ($15 a month) for Etsy and other online shops.
Questions
Which boards does it fit?
The ESP32 Supermini C3 and S3. Each has its own print profile.
Do I need screws?
No. The board clicks into the case and the lid clicks on.
Can I sell printed ESP32 Supermini cases?
Yes, with our Commercial License: Local ($5 a month) for markets, craft fairs and school fairs, or Online ($15 a month) for Etsy and other online shops. The free download is for personal use.
More Electronics
ESP32 Stream Cheap Deck · ESP32 Supermini Breakout Case · ESP32 Dev Board Case